![change mac address using terminal emulator change mac address using terminal emulator](https://cracktech.net/wp-content/uploads/2020/12/Change-MAC-Address-on-rooted-Android-182x300.jpg)
![change mac address using terminal emulator change mac address using terminal emulator](https://i2.wp.com/technofizi.net/wp-content/uploads/2017/12/Locate-MAC-Address.jpg)
You can connect via a serial port (as described in section 4.3) and issue the ip command:Ģ: eth0: mtu 1500 qdisc pfifo_fast qlen 1000 4.2.1.1 Address discovery – serial connection This allows an Affinity to be detected using Guralp Discovery Software - see section 4.2.1.5 for details. If your network includes Güralp Minimus digitisers, Minimus+ digitisers or Fortimus accelerometers, you can enable the guralp-responder service. If you cannot learn the IP address in this way, there are three methods available to discover which address has been allocated. The MAC address is displayed by the ip command – in the example in section 4.2.1.1, it is 00:50:c2:40:54:75. When using DHCP, it is recommended that the DHCP administrator allocates a fixed IP address to the Affinity's MAC address in order to avoid unexpected address changes. The LCD display shows lots of information so you may have to wait a short time until the IP address scrolls into view.
![change mac address using terminal emulator change mac address using terminal emulator](https://i.ytimg.com/vi/OLzIXtwmPs0/maxresdefault.jpg)
If your Affinity has an LCD status display, the assigned address will be displayed in it. Your network administrator should then be able to tell you the address that has been assigned. If your network uses DHCP to assign addresses, simply connect the Affinity to the network and wait a few minutes for the process to complete. The Affinity is supplied configured for DHCP. The web-configured address will take effect when the unit is next rebooted. Note: If you are setting up a unit in the laboratory for subsequent deployment in the field, you can set up the final network address using the web interface but then over-ride it with a temporary, static network address using the command line.